T2/T2C VG Rigging, Cord and List of Pulleys

posted in: Articles, Service | 0

T2 VG Rigging CB Corner

Qty Part No Description Comment
1 20P-1270 BEARING .5 OD .312 ID .156 TH Located at base of downtube plug, most important item to replace regularly to reduce friction
1 45K-1509 VG ROPE – T2 LOWER This is a fabricated item with a sewn loop on one end. The sewn loop is attached to the becket on the 20P‐1207 pulley shown on the following image by larks-heading it around the becket

Qty Part No Description Comment
1 40P‐5201 WIRE VG LEG PULLEY This pulley can only be replaced by replacing the wire
1 20P‐1207 PULLEY RONSTAN SINGLE W/BECKET

T2 VG Rigging Downtube top

Qty Part No Description Comment
1 20P‐1270 BEARING .5 OD .312 ID .156 TH Located in the top end-plug, secured by the bolt, as shown.
1 20P‐1237 PULLEY HARKN 16mm AIRBLOCK CHEEKBLOCK

T2 VG Rigging Noseplate

Qty Part No Description Comment
1 20P‐1237 PULLEY HARKN 16mm AIRBLOCK CHEEKBLOCK

T2 VG Rigging front Keel-beam

Qty Part No Description Comment
1 20P‐1206 PULLEY RONSTAN SINGLE

T2 VG Rigging Rear Keel-beam

Qty Part No Description Comment
2 20P‐1230 PULLEY HARKN SHEAVE TOP LEG VG Installed in back of center wedge

T2 VG Rigging Hang Tower

Shows VG-routing around hang pillar

T2 VG Rigging Keel

Shows overall routing in rear and through keel-beam sled

T2 VG Rigging Hualback Pulley

Qty Part No Description Comment
1 40P‐4210 WIRE XBAR SWEEP T2 W/PULLEY Pulley can only be replaced by replacing sweep wire
37ft 30J‐3012 CORD ‐ 3MM OC3‐3Y YELLOW This is raw line, used for the rear rope shown, and the front rope shown earlier, that terminates in the pulley inside the top of the downtube